Raw Hm1000x o rings for q/fill

[maxtich]

Any member can let me know where to get the correct o rings that for a raw Hm1000x with v quick fill
The O rings that go on both sides of the V  fill ?
Thanks

[Ca_Varminter]

BS017....

Stuart

[maxtich]

Hi Stuart
I've checked that out and it shows them as 70 Shore hardness..
I'm lead to believe they should be 90 Shore??
Thanks
Tich

[Ca_Varminter]

I have been using 80-90 shore hardness.... without any problems..
Stuart

[maxtich]

Ok Stuart..Following on from your recommendation..I've ordered a fair few of these,I'm hardly going to use all!
If any members should need any..plz let me know..I'll send them to you.
Tich


BS017 Nitrile 90 O'Ring (50x)

[Dave74]

I got a few packs of the oring kits from bagnell and Kirkwood they got the orings for the quick fill

[maxtich]

Ok Members..I've had a delivery of a good few o rings for Raw quick fill kits.
If anyone needs any just let me have your address and I'll post them f.o.c
Tich

[Mattb]

Great gesture

[KevG]

nice gesture Tich m8,what size did you end up ordering
kevG

[maxtich]

Hi Kev
These as Suggested by our own  Ca_Varminter from over the pond  ...

BS017 Nitrile 90 O'Rings pack of 50
Are these correct?
Would you like some..lol
P.S I've not tried them yet..for about £5.50
Tich

[Dave74]

Forget my pm
Tich, I've just ordered some too thanks for the info

[maxtich]

Hi Dave
I've only just got your p.m!!
I've got loads I would have sent you some!
Tich

[KevG]

Hi Kev
These as Suggested by our own  Ca_Varminter from over the pond  ...

BS017 Nitrile 90 O'Rings pack of 50
Are these correct?
Would you like some..lol
P.S I've not tried them yet..for about £5.50
Tich

is that for the later RAW,I've always used 18 by 1.5 mm on the banjo on the RAWS that bso17 size is also used on the old theoben pressure gauge banjo
kevG

[Dave74]

Ones I ordered are 17.7 x 1.78

[maxtich]

These are what I've bought:

These O'Rings are made from Nitrile and have an ID of 17.16mm and a 1.78mm cross-section.
Tich