Raw Hm1000x o rings for q/fill

[KevG]

the banjo internal groove must be bigger than the standard normal ones then as 1.5 section is a very tight fit
kevG

[maxtich]

I'm not going to tempt fate..by taking it to bits to find out if these fit..lol 
Kev do you thing these are the correct I rings!

[KevG]

I've never known for bso17 fit the banjo on  either theoben/raw or impacts.its always been 18mm by 1.5mm.the bso17 was used on the theoben pressure gauge theoben adaptor .if you measure the reg diameter were the banjo fits its 18mm on all the rapids and raws/Impacts.
kevG

[maxtich]

I've ordered by details given to me by our very own admin ..
To measure that I've got to strip it down..I'm Not going to tempt fate 
Tich 

[Dave74]

I will measure them today from the service kits I bought, I've already used them and fixed a leak so the ones in the kit are good

[maxtich]

Tempting fate..I'm sure I still had a tiny leak as the gage had dropped over a couple of weeks!
I changed all the o rings ..found a possible suspect o ring on the valve.
fitted all new o rings and then also the new Banjo o rings that I'd ordered and they fit perfectly!

[jackrooz]

Ok Members..I've had a delivery of a good few o rings for Raw quick fill kits.
If anyone needs any just let me have your address and I'll post them f.o.c
Tich

if you can give me the correct size for the banjo in a raw quick fill please

[maxtich]

BS017 Nitrile 90 O'Rings These fit in my Raw Hm1000x V quick fill
But they Don't fit the 180 version to the Rapid and Impact air that I've got!
Hth

[jackrooz]

ahh that's what I'm after I have the vtype quick fill

[maxtich]

No worries Mate..
Send me your address and I'll put a few in the post
Cheers

[jackrooz]

thanks.. I think dave74 just answered this post a bit earlier today ..im sure his said he'd post a few ..if however not.. ill send you a pm


thank you much appreciated
jack

[maxtich]

Ok Mate
Let us know if u need any
Cheers