AR 15 stocks

[Rapid7bee]

Hi all,is there still access to the hammer adjuster with the AR15 stock fitted or would I have to remove block screw or just rear tube pad?
What's the price on these also.
Cheers

[Joepineapples]

Hi all,is there still access to the hammer adjuster with the AR15 stock fitted or would I have to remove block screw or just rear tube pad?
What's the price on these also.
Cheers

Have pm'd you as didn't want to advertise as such.
If you look at a couple of the previously posted photos you can see the chassis comes up too high to access adjuster I'm afraid.

Thanks for the kind words guys.
A combination of things has meant I can start making them again and we have a MK1 in R&D at the moment which is exciting
All the best everyone!

[Joepineapples]

MK1 is up and running

[angrybear]

Mine came from ebay, 3D printed, is it one of yours Joe ? turned out OK.

I've just bought a little mill & was going to try making one from Acetal as the ally one's seem quite heavy.
I really like the look of yours above, the sides are that bit higher, mine could do with a bit more chassis at the front closer to the bottle.

[Joepineapples]

Yup, one of mine
Acetal would probably work well. If you decide to give it a bash pm me and I can lend you the buffer tap if you need one. The bugger at the moment is sourcing the buffer tubes

[angrybear]

Yup, one of mine
Acetal would probably work well. If you decide to give it a bash pm me and I can lend you the buffer tap if you need one. The bugger at the moment is sourcing the buffer tubes

Most kind, I'll certainly take you up on the offer  The acetal is already on order 
I've actually already got the buffer tube as my stock came with one, (from SGC) as well as having the tube fitted in your chassis,
Rifleworks have tubes listed as in stock around £30

[DAVYW1]

These look a great job and modernise the look of the Rapid alot.

[DAVYW1]

Pm sent re info and pricing.

[Joepineapples]

Replied, sorry took a while.

Angry bear, just holla when you want it

[Walk]

MK1 is up and running

Looks Amazing would it fit the MFR Cheers great work ATB

[Ca_Varminter]

Looks Amazing would it fit the MFR Cheers great work ATB

It should since the MFR is essential the Sexy Sister of the MKII

Stuart

[Walk]

Looks Amazing would it fit the MFR Cheers great work ATB

It should since the MFR is essential the Sexy Sister of the MKII

Stuart

 

[Walk]

Can they be made from Aluminium cut some slots out each side to lighten it up should be lighter than a wooden stock the shoulder can be as it is looks great ATB .

[Ca_Varminter]

Can they be made from Aluminium cut some slots out each side to lighten it up should be lighter than a wooden stock the shoulder can be as it is looks great ATB .

Yes if you access to a Mill...

Essentially there a 3 main components:
Main chassis Channel stock with a 1" channel
Rear block that the Stock extension tube screws into.
Finally the trigger guard.
Then of course the misc. fasteners needed to assemble.
This all was done on a Manual Mill by 220Swift over here on my side of the Pond!

Stuart

[angrybear]

I also made one from a block of Delrin, "good from far but far from good" as they say, but does me.