Dog screw

[Remchester]

It defo a gm its got a gold body and 2 stage and set up super light! It's like an anschutz match 54 rimfire trigger I love it!👍

[Remchester]

I like it but the stippling is slightly sanded so needs sharpening back up then a lick of oil on it the seal it back up and shes almost done if I ever get that pesky dog screw out the blooming bolt!

[Remchester]

That is a very nice looking stock if I may say so.
Some very nice grain and a very nice colour.
Most of them stocks I have seen have been very dark in colour.
Regards kev.

It's been sanded down before I got it its lost a fair bit of stippling off it I'm a stippling fan so want to get it re done think it needs to be sealed again with a little oil or wax to stop it soaking any dirt in just not had much time with it not even shot it at range just over the chrono!

[Dazgrif36]

Looks like clean gun some good bit of loving care will sort it out  and some oil on stock

[Ca_Varminter]

dont use a ball end type as these can break of.then your in shit creek.even expensive keys such as snap on or bondus can break on the ball end.
KevG

That is Very True.
But the Ball End is not for torquing on or breakin loose screws!!!
Strictly used to get the fastener on or off..
That is why the ball end is on the Long portion, with the short end as the torquing lever!
So You can't apply enough torque to snap...unless you use a torque extension!!

Stuart