MK 1 Rapid

[Walk]

Hi fellas my friend as brought a MK1 Rapid 7 22 the mag that came with it was not working when inserted into the rifle the bolt and the pellet probe not pushing pellet into barrel his friend went down with one of his 22 mags and it was doing the same what could be wrong any help please ATB Fellas 

[Brooksy]

Where abouts in Staffordshire are you?
I'm in Crewe, I could take a look at it if you like.

[Ca_Varminter]

First start with the Mag.
Load it up, then pushout the pellets with dowel.
Make sure they pushout with any catching.

Next check the breech of the barrel.
Some pellets like Bis-Mags are harder,
The may cause lead transfer when loading!
This can cause the breech to lead up to the point of extremely hard to load!!

Also check the alignment of the inner and outer pellet probes.
Make sure they are straight and concentric to the bore..

Other than that...It may need a check up with KevG..

Good Luck,
Stuart

[Walk]

Hi the magazine works fine he tried one his m8 brought down that failed to so will get him to clean barrel and try again and to look at the probe in and out and line up cheers ATB Buddy 

[Walk]

Where abouts in Staffordshire are you?
I'm in Crewe, I could take a look at it if you like.

From Rugeley Town Buddy he brought the gun from a shop second hand for £995 and a new dive bottle for over £200 looks nice got it home and went to set a scope up but the mag was not working His m8 tryed one of his mags and it was the same would not work in the gun so that's were he is at the moment Buddy ATB PS the rapid was brought  from Bamford's gun shop Saturday . they said it work fine at shop we could not try it at shop as no were to test it in till we got home . ATB .

[Brooksy]

Is the scope low and touching the magazine and preventing it locating correctly?

[Walk]

Is the scope low and touching the magazine and preventing it locating correctly?

Hi no m8 it clears scope he is taking it back to the shop Saturday he wants his money back to be honest the shop should of made sure the rifle was good to go He rang them and they said bring it back shame really . ATB Buddy   

[angrybear]

Sounds like a fault with the pellet probe could be a pellet fallen back inside blocking the outer probe, does the bolt cycle correctly with no mag ?
can you hold the outer so the inner probe pushes out