Mk2 Sporter Trigger sear strut tension spring

[Chips]

Does anyone know the dimensions of this spring or better still where I might source one ?
It's the early Theoben sporter trigger for the mk2 with sear lever arm.
Many thanks.

[Ca_Varminter]

I am Sure KevG can source or make one..
I need to dig through my parts bin.. I can give you a measurement Tomorrow!

Stuart

[KevG]

not got any left,next time I get the chance will get one and get a few copies.could be months though.
kevG

[Chips]

I am Sure KevG can source or make one..
I need to dig through my parts bin.. I can give you a measurement Tomorrow!

Stuart

Cheers Stuart - hopefully not too rare a beast - dimensions / spec would be much appreciated.
C.

[Chips]

not got any left,next time I get the chance will get one and get a few copies.could be months though.
kevG

Ok thanks Kev - much appreciated.

[Chips]

I am Sure KevG can source or make one..
I need to dig through my parts bin.. I can give you a measurement Tomorrow!

Stuart

Hi Stuart - any chance u can send me measurements / spec for this spring ? Apologies for being a pest ! El desperado here mate - want to start digging around, see if I can't track one down.
Many thanks,
C.

[Ca_Varminter]

Sorry I didn't get out to my little shop..... Had to do some computer work.. real job....
Ok this is what I got:
Outer Diameter:  3mm  .1185"
Inner diameter:  .194mm  .076"
Wire Diameter:   .5mm. .0200"
Spring Length:   16.79mm. .661"

Hth,
Stuart

[KevG]

wire section is 0.70mm
kevG

[Chips]

Thank you gentlemen - much appreciated. Will keep asking around. Please let me know if you hear of / get your hands on a fresh supply.
Have a good weekend,
Charlie.