Valve chamber extension and stem stand off

[KevG]

For the longer blocks
KevG

[Ca_Varminter]

Those look amazing...Great Finish..Stainless?

Stuart

[KevG]

Cheers stuart m8.yes I like doing things in stainless.
KevG

[KCE]

Are those what I saw today kevG.
The same as you fitted on mine which I have noticed a vast improvement in the past few weeks.
When I look at it on the rapid it is as though it was part of the gun when it came from the factory it really does blend in with the action.
Regards Kev.

[AustenW]

Looks great Kev, I bet the customer will be pleased with that 

[KevG]

hope so m8.could not leave it while tomorrow.so finished it tonight,just the carbon tube to fit now.
KevG

[KevG]

Are those what I saw today kevG.
The same as you fitted on mine which I have noticed a vast improvement in the past few weeks.
When I look at it on the rapid it is as though it was part of the gun when it came from the factory it really does blend in with the action.
Regards Kev.

yes kev m8,but made the stand of after you went,was going to do it tomorrow but once i get started i carnt stop.
KevG

[Daztilley]

Looks great kev 👍
That will add loads of air capacity to the valve chamber 👍👍👍

[KevG]

got something similar in my little .20 cal daz and its realy upt the shot count.
KevG

[Daztilley]

I remember seeing a pre chamber fitted to the bottom of the block too - have put pics below.....
With MFR s being fitted with a shrouded barrel there isnt space to fit a chamber below the barrel - looks a tidy piece of work too 👍

[Ca_Varminter]

OMG...
That just reminded me another pre-chamber connected through the bottom of the receiver.
Swift on AirguAdvice...His .50 cal Big bore Rapid project....
I don't have any photos

Stuart

[Daztilley]

That sounds interesting Stuart! Never seen a  50 cal rapid either 😲

[GordonM]

For the longer blocks
KevG

Hi Kev, whats a HEIC file and what will it open with


G

[Ca_Varminter]

apple device

[Ca_Varminter]

Hey KevG...
Do You Send to the States???


Stuart