Theoben Rapid Forum
Everything Technical About Rapid => Technical => Topic started by: Chips on September 05, 2023, 07:43:19 PM
Does anyone know the dimensions of this spring or better still where I might source one ?
It's the early Theoben sporter trigger for the mk2 with sear lever arm.
Many thanks.
I am Sure KevG can source or make one..
I need to dig through my parts bin.. I can give you a measurement Tomorrow!
Stuart
not got any left,next time I get the chance will get one and get a few copies.could be months though.
kevG
Quote from: Ca_Varminter on September 06, 2023, 01:13:58 AMI am Sure KevG can source or make one..
I need to dig through my parts bin.. I can give you a measurement Tomorrow!
Stuart
Cheers Stuart - hopefully not too rare a beast - dimensions / spec would be much appreciated.
C.
Quote from: KevG on September 06, 2023, 08:04:18 AMnot got any left,next time I get the chance will get one and get a few copies.could be months though.
kevG
Ok thanks Kev - much appreciated.
Quote from: Ca_Varminter on September 06, 2023, 01:13:58 AMI am Sure KevG can source or make one..
I need to dig through my parts bin.. I can give you a measurement Tomorrow!
Stuart
Hi Stuart - any chance u can send me measurements / spec for this spring ? Apologies for being a pest ! El desperado here mate - want to start digging around, see if I can't track one down.
Many thanks,
C.
Sorry I didn't get out to my little shop..... Had to do some computer work.. real job....
Ok this is what I got:
Outer Diameter: 3mm .1185"
Inner diameter: .194mm .076"
Wire Diameter: .5mm. .0200"
Spring Length: 16.79mm. .661"
Hth,
Stuart
wire section is 0.70mm
kevG
Thank you gentlemen - much appreciated. Will keep asking around. Please let me know if you hear of / get your hands on a fresh supply.
Have a good weekend,
Charlie.