Valve chamber extension and stem stand off

[KevG]

Depends if your m8 Donald Trump says it's ok.😁
Yes I have done in the past stuart m8
KevG

[Ca_Varminter]

Depends if your m8 Donald Trump says it's ok.😁
Yes I have done in the past stuart m8
KevG

He Is No M*8 of mine...
I was hoping he would stay on your side of the Pond With Boris!!!

Thanks,
Stuart

[Lanky94]

got something similar in my little .20 cal daz and its realy upt the shot count.
KevG

What spec stainless did you use Kev? What wall thickness if it also please?

[KevG]

316 stainless 2.9mm wall on main chamber and 2.3mm wall were thread relief is.
kevG

[Lanky94]

Thanks Kev. Have you made any from titanium? I would imagine weight penalty for stainless compared to titanium is negligible for such a small amount of material used?

Do you cut the thread using lathe, or use a die?

[KevG]

do it on lathe.stainless would be tough to do with die..sooner do them out of stainless.i guess they could be done in brass but always think it looks a bit naff and cheap.
KevG

[Brooksy]

I thought you Yorkshire men loved brass! But only if it stays in your pocket I suppose! 

[Kernal]

I thought you Yorkshire men loved brass! But only if it stays in your pocket I suppose! 

nice,

[jackrooz]

I wonder if you could make up something like this for me ..

would need to go between the regged raw quick fill as in the picture..


have no idea on cc capacity I'd imagine 2cc