Probe adjustment

[Stevep123]

Hi Kev
Yes that's the one.I've had a look today the inner  probe had unscrewed from the base at the back,back together all sorted.
It's shooting spot on with your reg in now

[KevG]

yes seen this happen before did it with one of mine,worth putting a bit of thread lock on the thread,glad it ok for m8.
KevG

[angrybear]

Hi Kev
Yes that's the one.I've had a look today the inner  probe had unscrewed from the base at the back,back together all sorted.
It's shooting spot on with your reg in now

Not sure I get you, but do you mean the inner probe shaft had come away from it's base ??

[Ca_Varminter]

Not sure I get you, but do you mean the inner probe shaft had come away from it's base ??

The inner probe is a 2-piece design...
So the base is used in all Rapids...
On the probe is different for .177, .20-.22, and .25 cals
So the base has a concentric nub that is threaded.
And the end of the inner probe shaft is threaded..


Stuart

[Stevep123]

Yes exactly as Stuart said,it had somehow unscrewed from its hub/base.I Kev I did put a bit loctite on it so should be fine now also cleaned all the grease out

[Ca_Varminter]

All you need was a couple of strands of fur from the Rabid Fox.
That would Lock-up anything!!!


Stuart

[angrybear]

Cheers for that, I hadn't noticed, but of course makes complete sense.

[KCE]

I set you off with that rabbid fox stuart glad to see it ongoing still.
I paid it a visit few weeks ago it has not lost any more teeth yet.

Regards kev

[Ca_Varminter]

But has it gain more spider webs??
Just makes it look more Rabid!!

Stuart