Raw HM1000x questions

[Aggy]

Hi guys a couple of questions for the experts
I have just bought a sub 12 .22 chassis rifle with the sole intention of adding it to my other section one rifles .
At the moment the only thing I have done is shoot it over the chrono and it is very very consistent.
The reg is set to 100 bar ,it's written on the bottle adapter,
The anti tamper on the hammer spring is a a plastic disc that has been removed as it is impossible to gain access to the hammer spring service adjust anything with it in place .
The hammer spring is the usual black delrin spring guide outer spring inertia weight and the inertia spring , a washer at each end .
The the springs feel like they binned when cocking the gun and that feels a bit rough , the washers feel like the are stamped , bevelled and aren't flat ,that could be adding to the feel
The transfer port I. The barrel is tiny but it will be being a sub 12 .

So questions
Best way to improve feel without effecting consistency
Will the normal rapid reg tester work with the raw , it will need turning up
Not been deep enough to get to the hammer and valve so don't k ow what these are like , weight port size ect what size the consensus on them .
No rush at the moment the gun is staying as it is until after Xmas and I get another subby to replace the gap thi so one will leave .
Also thinking on sticking ina variation for a .25 barrel so recommendations on that please 

[Squinty]

apparently the latest Air force X series blocks have  wider plenums and 3/4"  threads instead of the original 5/8.
Guess you'll need an adapter.

The rest would probably benefit from a polish, hammer, spring ends, slip washers ect.. same as a Rapid?

[john79]

theses hm1000x seem to be a bit thin on the ground over here wots the reason for this?

[Aggy]

Raw only fulfilled part of the order elite optical placed , I waited 9 months from ordering mine , It is a belting gun that will get better