Welcome to Theoben Rapid Forum. Please login or sign up.

Members
Stats
  • Total Posts: 22,073
  • Total Topics: 3,204
  • Online today: 23
  • Online ever: 1,511 (July 25, 2026, 07:29:23 PM)
Users Online
  • Users: 0
  • Guests: 22
  • Total: 22

Twitter YouTube Facebook

Theoben Rapid Forum

Click above to make a donation. Thank you for supporting The Theoben Rapid Forum.

theoben rapid mk2 video ?

Started by stefan, June 02, 2020, 08:37:47 PM

Previous topic - Next topic

stefan

evening all  does any one know of any videos showing a full strip down of a mk2 ? as i wouod love to learn know how to do my own service on it and learn more about it  as in polish this dont polish that  ect ect ect  thanks all stefan

KCE

#1
Hi Stefan.

Take a look in the Technical section and the airgun data section on here you will learn a lot from there as to what you need to know about your rapid.
Regards KCE.
Regards KCE
Admin.

stefan


Squinty

there's not much to the actual strip down, they really are that simple
this is with the earlier sporter trigger unit... mk4 is two pins

Doesn't get any harder than this.....

https://www.jimmiedeesairguns.com/guides/service-guides/theoben-rapid-mkii-service-guide/a-service-guide-for-the-theoben-rapid-mkii/

what to polish...?
the hammer.... polish not sand!
you can polish the hammer spring ends assuming that they are well finished to start with.
No need to polish the bolt... really... just the tiniest amount of molybdenum sulphide grease


PiL

Thanks for posting the link to that tutorial, Squinty 👍. Even though mine is a mk1, the detail and the pics put up there-in were very informative, often wondered what the blanking seal plate in the bottom of the block was for 👍.
I was going to ask on here, if I changed where the bottle valve goes into, to a regulator, could I fill my carbon bottle to 300 bar. Going by the tutorial, if I read it right, other work on the block would need to be done, is that right?

Squinty

I don't know how much the regs will take, RAWs go 250 > 300.
I asked Kev if I could go to 250bar...not that I need to
He said shouldn't be problem but he only fills his FAC to 230.

Block mods depend on the age but non-reg blocks have different porting as they run higher inlet pressures


KevG

The regs should work fine upto 250 bar.but not the early circlip type.200 bar for those
KevG
Regards KevG.
Administrator

jps

Quote from: KevG on June 07, 2020, 08:36:00 PM
The regs should work fine upto 250 bar.but not the early circlip type.200 bar for those
KevG
That's good to know as the reg in my late Mk1 is the early cirplip type
RUNT

This website is proudly hosted on Crocweb Cloud Website Hosting.

Crocweb Cloud Website Hosting

Welcome to the Theoben Rapid Forum

© 2026 Theoben Rapid Forum. All rights reserved.