What? How?

[Squinty]

Always have a good look on Eblag for Rapid bits.
Saw an S-type stock and flicked through the images.
The back is slotted and well it has a QF cut out which is a shame.
Then I got to the last image in the gallery..

[rye_1977]

Maybe it was drilled and tapped for a pressure gauge 🤷

[Squinty]

Maybe it was drilled and tapped for a pressure gauge 🤷

on the thinnest part of the block?

[rye_1977]

Maybe it was drilled and tapped for a pressure gauge 🤷

on the thinnest part of the block?

It certainly wouldn't surprise me. I've seen alsorts over the years....I'm sure it's been done before. Looking where it's situated I'd probably say so..

[Ca_Varminter]

 I think the Person screwed up their Measurement!!!
And cut a Very Clean hole in the Wrong Place!!

    
Stuart

[rye_1977]

I think the Person screwed up their Measurement!!!
And cut a Very Clean hole in the Wrong Place!!

    
Stuart

Yes stuart.....it looks a good inch or so off! 🤪🤣

Rye