Can anyone advise on how the mk2 sporter trigger is adjusted ?
Its not bad, but I'd like the break a little lighter.
Can this be swapped out for a mk4 trigger unit ?
Thanks
Here is my Tech post on adjusting the MK II Sporter Trigger..
https://rapidforum.co.uk/forum/index.php?topic=275.0
The sporter trigger is not a Cartridge style trigger...
It requires you to Machine the Receiver and drill it for the trigger pins...
My MK II Sporter was the First one Converted!!
I had a World class Airgunsmith, do the work... on my side of the pond.
He did notified Theoben about how to do it.. so they used to offer the service..
So it can be done..
(https://photos.imageevent.com/scl_electronics/gun/air/websize/mytrig.jpg)
hth,
Stuart
Quote from: Ca_Varminter on September 12, 2020, 05:26:51 PM
Here is my Tech post on adjusting the MK II Sporter Trigger..
https://rapidforum.co.uk/forum/index.php?topic=275.0
The sporter trigger is not a Cartridge style trigger...
It requires you to Machine the Receiver and drill it for the trigger pins...
My MK II Sporter was the First one Converted!!
I had a World class Airgunsmith, do the work... on my side of the pond.
He did notified Theoben about how to do it.. so they used to offer the service..
So it can be done..
(https://photos.imageevent.com/scl_electronics/gun/air/websize/mytrig.jpg)
hth,
Stuart
Thanks Stuart
which version is yours Rob as they come in a couple of variations.its just the inner centre grub screw that needs turning out a little at a time and test.the first stage travel can feel hard on these triggers but a weaker spring and a good polish can improve this.
KevG
Hi Kev
Not sure which one it is. I'll have a better look tomorrow
First version as a piston thats in direct contact with hammer then they improved it by fitting a lever inbetween the piston and hammer.you can tell as this later one as a window cut out on the side of action.you can see this when you remove stock.
KevG
Quote from: KevG on September 12, 2020, 09:20:22 PM
First version as a piston thats in direct contact with hammer then they improved it by fitting a lever inbetween the piston and hammer.you can tell as this later one as a window cut out on the side of action.you can see this when you remove stock.
KevG
I'll have a butchers tomorrow
Thanks
This is the rifle
Quote from: Robs5230 on September 12, 2020, 11:41:12 PM
This is the rifle
take hammer, apply repeatedly
no, am not jealous a bit :-X
Quote from: KevG on September 12, 2020, 09:20:22 PM
First version as a piston thats in direct contact with hammer then they improved it by fitting a lever inbetween the piston and hammer.you can tell as this later one as a window cut out on the side of action.you can see this when you remove stock.
KevG
Hi Kev
Guessing you'll know which one this is then ? :)
Only 1 grub screw behind the trigger blade.
Yep..
Single spring in the sear-strut, with sear lever ..
It is all in my tech post...
Good Luck,
Stuart
yes thats the later one with lever added.before this there was no cut out window and no lever.
KevG