I've noticed through scope I get odd pellets starting to spiral through air like tumbling not flying straight then get few that fly strait anyone no what causes this
Bad pellets, damaged skirt on pellet, clipping if you're using a mod' can be any of the above I guess
I've checked pellets they seem fine no damaged skirts it started happening with jsb heavys so I switched back to accupells and these seem ok at minute unless the barrel likes thicker skirts and lighter faster pellet than slow one it is 19inch barrel too and it doesn't look like it's got crown either its s type barrel anshutz I believe
Stick on a pic of the crown mate 👍
it as a crown daz.its how theoben did them.
KevG
Thought It would kev but cant tell on this I'll get pic of it
There u go
possible causes
Probably has a tight choke if it prefers Accupel to JSB, they are made from a harder lead alloy which doesn't deform as easily.
My old FAC barrel would only shoot the harder leads, everything else was mangled by the choke.
S£%! batch of JSBs; their method of altering the skirt to compensate for small dies and adjust BC can upset the balance.
Worst was a batch of AADF-H which tumbled and literally fell out of the air at 45-50yds like running into an invisible wall.
Can't really tell if the crown is sharp in the pics but if that ring isn't from a grub screw ....its an over compessed choke
Yes I can see that ring it has got very tight choke when I rod pellet down it stops then got to give it good push to get out I'm thinking to take choke off and recrown who does it .
Recent reports of Hades pellets 'misbehaving' at the end of travel, are you using this type?
Has the rifle been performing well, or has it always done this?
atb
Bob
Quote from: Dazgrif36 on August 31, 2020, 08:49:06 AM
Yes I can see that ring it has got very tight choke when I rod pellet down it stops then got to give it good push to get out I'm thinking to take choke off and recrown who does it .
m old barrel was 5.39mm in the grooves and there was a difference in o/d of the choked section.
Should have been 15.75 +/- but was 15.5
Had problems with the mod clipping because it was 0.2mm smaller at the crown and the mod could be bumped out of line.
Yes I'm having the choke removed now and crowned see how it goes then
the choke was not that tight daz.if you remember when I roded the air arms through they popped out easy and very light rifling marks on the pellet.
KevG
have you tryed singal loading as some of the mags can be over tensioned and damage the fragile .177 skirts.i had to de tension all my .177 mags.
KevG
It is with like hn accupells it should be better with no choke surely less pellet fussy hopefully
you never know with barrels.could make it better or worse.have you also tryed with out silencer.
KevG
It is quite tensioned yeah kev but cant see that causing problem
yes it can.as if it cycles to fast and hard the pellet skirts can get damaged on the stop.the .177 is prone to it as its much more fragile on the skirts.
KevG
its up for sale anyway ain't it, so will you pass the problem on Daz or get it sorted out before someone buys it for £850 ??
I'd try a different tin of JSB/AA...die to die they can be completely different.
It's ok now it was pellets and cleaned barrel out cheers guys