Print Page - Machining cost

Title: Machining cost
Post by: Remchester on August 29, 2020, 10:13:22 AM

How much would/will it cost to have a barrel spun up to fit a rapid? How much are newly made regs and suppressors?

Title: Re: Machining cost
Post by: Dazgrif36 on August 29, 2020, 01:22:01 PM

Turn down barrel to fit rapid shudnt be that much with someone who got lathe and kevgs regs are bout 110quid think message him on here .

Title: Re: Machining cost
Post by: KCE on August 29, 2020, 02:38:03 PM

Yes I agree with the above im sure KevG will sort barrel out for you in no time.
Regards Kev.

Title: Re: Machining cost
Post by: KevG on August 29, 2020, 08:06:21 PM

if its a silco barrel your talking around £30 for machine work and fitting.regs start at £100 for a mk2 type reg.
KevG

Title: Re: Machining cost
Post by: Remchester on August 30, 2020, 07:09:51 AM

Quote from: KevG on August 29, 2020, 08:06:21 PM
if its a silco barrel your talking around £30 for machine work and fitting.regs start at £100 for a mk2 type reg.
KevG

Thanks kevg I was supposed to come over to have my rifles looked over by you and have a chat about what can be done to them with you right at the start of lock down buddy! I doubt you will remember as you are one busy man! I haven't botherd you since as I know you are flat out most of the time and dont want to pile on to the work load mate! But if it's ok with you I'll give you a call when I can and re arrange with you when I can get over

Title: Re: Machining cost
Post by: KevG on August 30, 2020, 08:34:32 AM

yes thats fine m8.
KevG

Title: Re: Machining cost
Post by: Remchester on August 30, 2020, 11:52:25 AM

Quote from: KevG on August 30, 2020, 08:34:32 AM
yes thats fine m8.
KevG

Thanks kev I work shifts so I'll be In touch as soon as i can bud👍👍

Theoben Rapid Forum

Everything Technical About Rapid => Technical => Topic started by: Remchester on August 29, 2020, 10:13:22 AM