Just a thanks to Bob for getting the quickfill out in smart order ;)
First time I've done one.
Needed a V as I plan to shroud this at some point. I was planning to run a 100cc bottle but relented and used a BSA superten 200cc bottle. Very nicely balanced.
Bricking it when I started cutting even though I'd measured about 3 times.
Turned out pretty well, but I have had to open the side of the filler nipple a little bit more after I took the pic to get the fill connector on.
Happy with how it turned out.
Nice one matey, tidy job and no removing the bottle. It will be nice with the 200cc bottle too 8)
Nice looking good there.
Looks very neat and tidy.
You cant go wrong with Dr Bob and his bits.
Regards kev.
And holding air after 2 days so thats a bonus :)
Quote from: Robs5230 on August 09, 2020, 06:59:23 PM
And holding air after 2 days so thats a bonus :)
Hi Robs5230
Who cut out the stock for you or was it you that cut out the stock because if so its a very tidy job you`ve done and i take my hat off to you,
Very nice indeed Robs5230
Regards
:)
Quote from: Kernal on August 09, 2020, 07:37:08 PM
Quote from: Robs5230 on August 09, 2020, 06:59:23 PM
And holding air after 2 days so thats a bonus :)
Hi Robs5230
Who cut out the stock for you or was it you that cut out the stock because if so its a very tidy job you`ve done and i take my hat off to you,
Very nice indeed Robs5230
Regards
:)
I did it .
A proper brown trouser moment. I've angled the cuts down at 45 degrees too to match the angle of the gauge and quickfill.
Very pleased with it.
Here's the quickfill side after I had to open it up a little
I have to admit you`ve done a really good job of that stock Rob, Nothing look`s out of place i hold my hat off to you, Top work and a fine job,
And as far as it goes for DrBob well he`s something else, And i think we can all thank him for creating parts for the Theoben Rapid he`s becoming a legend and his parts he make`s are second to none,
It make`s me proud to have him on this forum creating and helping out like he does,
:)
Thankyou for sharing Rob