Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: KCE on August 03, 2020, 12:53:46 AM

Title: Mk1/Mk2
Post by: KCE on August 03, 2020, 12:53:46 AM
Is thete an advantage witk mk2 block over mk1 block.
Regards kev.
Title: Re: Mk1/Mk2
Post by: Ca_Varminter on August 03, 2020, 01:05:42 AM
If you are looking at Factory setup MK I or MK II...
MK II has the larger pre-chamber..great for power in FAC, also efficiency..
Also you can't beat the Mark 4 trigger!

But if you have KevG and the rabid fox, do their magic..... not much!!

Stuart
Title: Re: Mk1/Mk2
Post by: KCE on August 03, 2020, 01:17:54 AM
Lol the rabid fox.
You crack me up stuart.
Regards kev.
Title: Re: Mk1/Mk2
Post by: Mickyd on August 29, 2020, 07:58:19 AM
Who or what is the Rabit fox. Md
Title: Re: Mk1/Mk2
Post by: KCE on August 29, 2020, 08:53:02 AM
Have you been to KevG workshop if so you will have seen the rabid fox.
If not I will send you a pic.
Regards kev.
Title: Re: Mk1/Mk2
Post by: Mickyd on August 29, 2020, 09:25:48 AM
Yep with you now, been to Kev's quite a few times and done a bit of work for him.md
Title: Re: Mk1/Mk2
Post by: Squinty on August 29, 2020, 10:34:16 AM
Around 1999- 2000..might be earlier.. the Theoben Rapid Systems block was machined with the deeper lower plenum.
Besides that the Mk2 trigger is the big plus, my GAMO trigger is pretty good butnnot a patch on the Mk4.
or if you single load. - the scalloped block is handy.
Only leaves porting... which is a few minutes of machining.
Title: Re: Mk1/Mk2
Post by: bob4026 on September 02, 2020, 05:29:42 PM
Quote from: KCE on August 29, 2020, 08:53:02 AM
Have you been to KevG workshop if so you will have seen the rabid fox.
If not I will send you a pic.
Regards kev.

I picked my MFR up from Kevs but i didn't see a rabid fox... can you post that pic mate?

Bob
Title: Re: Mk1/Mk2
Post by: Ca_Varminter on September 02, 2020, 05:44:45 PM
(https://photos.imageevent.com/scl_electronics/gun/misc/websize/kevgws21.jpg)

This little guy either has Rabies or Mange!!!
;D ;D ;D ;D ;D ;D ;D

Stuart
Title: Re: Mk1/Mk2
Post by: KCE on September 02, 2020, 08:01:16 PM
Oh yes there he is poor thing lol but it would not be the same at KevG without that being hung up in his work shop.
Regards kev.