Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Robs5230 on August 01, 2020, 08:29:56 AM

Title: Early mk1 stock options
Post by: Robs5230 on August 01, 2020, 08:29:56 AM
I have an early mk1 rapid with the standard schnabel tipped mk1 stock.

I'm looking to get Kev to fit a reg and probably one of Bob's quickfills, as I'd like to use a small bottle, but realise that the extra length of the reg and quickfill mean that the quickfill will likely protrude past the end of the stock.

Are there any other options of mk1 stocks that may help hide the quickfill ?
Thanks Rob
Title: Re: Early mk1 stock options
Post by: Squinty on August 01, 2020, 10:20:12 PM
You'll have to either cut the top for a 'V' 90 degree or put a 25mm hole in the bottom.
The reg will move the QF 15mm further forward than the short R7 bottle holder.
Doesn't leave much wood up front with either option.

The late mk1 ambi stock has a slightly longer fore end , the schnaebel  is extended  to accommodate the extra length of the mk1/2 fast flow.

Could splash out on a cs500 sporter stock but stock/reg/QF... it's a lot of money just so that you don't have to take a small bottle off.


#1 My mk2 in an early stock, the neck on the c/f bottle is 5mm longer...I can like with the gap.
#2QF on short holder still pushes the bottle out, can just see how  far forward the fill nipple is on the bottom...add 15mm with a reg