Just to show everyone thats new to seeing these fast flow valve`s that your buddy bottle is attatched too,
Below in the attatchemts are photos or the two types of valve`s that have no restrictions to air flow.
The Mrk2 fastflow can fit the Mrk1 but the bottle would be pushed forward due to the length of the valve being a little bit longer.
Thank you for the info Kernal most appreciated.
Regards Kev.
The one for the mk2 does not need a flow hole.that one must have been moded to fit the old mk1.
KevG
Was thinking that Kev.... probably to fit a mk1 block into a mk2 stock ....
several variations of the fast flow
left to right.....or not ;D
really need to see the images in the preview ;D ;D
.22 early Rapid 7......feeds through the theads
.22 later
Drilled waist .177
Early FAC /.177
Later Mk 1 / Mk2
Kernal,
To go along with your Bottle adapter Comparison....
Here are the MK I and MK II receivers side by side..
(https://photos.imageevent.com/scl_electronics/gun/swift/websize/MKI_MKII%20rcvr.jpg)
(https://photos.imageevent.com/scl_electronics/gun/swift/websize/MKI_MKII%20rcvr2.jpg)
Stuart
Something to look out for....back ported.....dual port fast flow Rapid 7 block
Hmm...
I know that Swift over on my side of the Pond..
Did a few conversion of old MK I receivers to MK II specs...
Deepen the the Pre-Chamber. Then Milled and drill the bottom access port.
Then drill the second through-Port!
Then installed MK II Fast-Flows....
Stuart
Stuart
seen a couple of blocks done like this besides my own with short core regs.
Actually bought a gun that had been opened up, thru-port and top transfer......badly.
Wouldn't shoot consistently fast flow or regged.
Just goes to show that you never know what's been done to a Rapid until you take it apart.