Theoben Rapid Forum
DrBob`s products & parts => Dr Bob's Section => Topic started by: Dr Bob on June 21, 2020, 09:48:15 AM
I'm not saying it's the best but for a mass produced valve at a reasonable price I think this is as far as it goes. It's made from Nylon 11 and is quite a bit harder than Delrin. The drawback is the valve seat has to be lapped in. The advantage is no way could you machine that curve
Still a fair bit of playing around to do but getting there. I need to brush up on my sectioning skills on close up it looks messy. For those of you watching in black and white the high flow is the top one.
Bob
watching 8)
Im watching this thread for future.
Regards Kev.
Nice Taper Valvestem Profile!!
Need to seem som numbers Now!
Great Job Dr Bob!!!
Cheers,
Stuart
Good work bob I will be keeping my eye on this
Nice work Bob 8)