Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Maxwell on June 10, 2020, 10:53:40 AM

Title: Rapid bolt handle
Post by: Maxwell on June 10, 2020, 10:53:40 AM
Can anyone tell me the size of the thread on a rapid bolt handle
Title: Re: Rapid bolt handle
Post by: Squinty on June 10, 2020, 10:59:19 AM
1/4 unf  28tpi
Title: Re: Rapid bolt handle
Post by: KCE on June 10, 2020, 11:53:36 AM
As squinty said that goes for the MK1 and the MK2.
Regards Kev.
Title: Re: Rapid bolt handle
Post by: Squinty on June 10, 2020, 12:35:26 PM
slightly shorter thread on those fitted to the adjustable bolt as it has to clear the probe adjuster pin that runs through the centre
Title: Re: Rapid bolt handle
Post by: Maxwell on June 10, 2020, 02:49:21 PM
Thanks lads very much appreciated
Title: Re: Rapid bolt handle
Post by: Ca_Varminter on June 10, 2020, 03:17:47 PM
(https://photos.imageevent.com/scl_electronics/gun/ultimaterapid/websize/MyBoltjpg.jpg)

Approximate 1/4 inch of threads......

Stuart
Title: Re: Rapid bolt handle
Post by: Daztilley on June 10, 2020, 08:17:46 PM
Very nice Stuart 😎
Title: Re: Rapid bolt handle
Post by: Ca_Varminter on June 10, 2020, 08:23:01 PM
Thanks,
These are Tactical knobs for Bolt Action Rifles.
I made stems for them out Stainless an Titanium.

Stuart
Title: Re: Rapid bolt handle
Post by: KCE on June 10, 2020, 08:25:50 PM
Very nice Stuart.
you have a thing for titanium which I do agree you cant get much better that that.
I bet it is not cheap to source and a pain to work with but the end results are worth the wait.
Regards Kev.
Title: Re: Rapid bolt handle
Post by: Ca_Varminter on June 10, 2020, 08:48:06 PM
Grade 5 isn't cheap...
But isn't that hard to work with...
The need of sharp tools are a Must!
Here is a photo on machining a new Valve-stem
Shaving off about .002 in.
(https://photos.imageevent.com/scl_electronics/gun/ultimaterapid/websize/thin%20cut.jpg)

Stuart
Title: Re: Rapid bolt handle
Post by: KCE on June 10, 2020, 09:16:24 PM
That is a cracking photo Stuart.
It was a long time ago when I did some work on a Lathe.
I worked with a Colchester student and a triumph.
Regards Kev.
Title: Re: Rapid bolt handle
Post by: Ca_Varminter on June 10, 2020, 09:22:52 PM
A Real Lathe!!
I wish I had the Room for one!!
That is Why I am jealous of KevG Shop!!

Stuart
Title: Re: Rapid bolt handle
Post by: Replay on June 11, 2020, 09:01:59 AM
I used to have two lathes,  Clark's lathe I think it was called a cs something, and my myford super 7.
Both good hobby lathes, but I found that you could buy the parts cheaper than making them yourself.

Regards

Replay