Theoben Rapid Forum

I have a @KevG  MFR reg fitted to my .177 Mk1 and I have some questions.


1.  What pressure should the reg be set at?


2.  How much end float should there be and where is it measured?


3.  What configuration should the 6 washers in the stack be in?


Thanks


Bob

Quote from: nevadacowboy on June 09, 2020, 01:16:15 PM
I have a KevG  MFR reg fitted to my .177 Mk1 and I have some questions.


1.  What pressure should the reg be set at?


2.  How much end float should there be and where is it measured?


3.  What configuration should the 6 washers in the stack be in?


Thanks


Bob

I was just about to ask what config the washers should be in on a microreg .177.  I don't think they are a simple <><><> layout

Sent you my number m8 as it takes a fair bit of explaining.if it's one of my regs the core travel is pre set and can not be or does not need adjusting.
KevG