Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: PiL on June 07, 2020, 02:36:26 PM

Title: Mk1 block
Post by: PiL on June 07, 2020, 02:36:26 PM
Thought I'd start another thread as I started to go off topic.
I've got a mk1 block and I use a Best Fittings quickfill and gauge to make it easier to fill and to see how much air is in the cylinder. Now, I've just bought a 300cc carbon cylinder (which can be filled to 300 bar) not that it has to. I would like to use the cylinder to its potential without modification to the block. Is it possible to do just by adding different parts? I'm not bothered about costs within reason, just looking to modernise an old format and if I decide to sell in the future then I can revert back to original. If it helps any, the block is 0114** .
Steve
Title: Re: Mk1 block
Post by: Squinty on June 07, 2020, 08:37:55 PM
Hi ya Steve

serial no 11*** , would have 'Theoben Rapid Systems' on the block?
Think these have the deeper lower chamber? @KevG ?

That gives more internal volume which in turn means pressure drops less between shots and can help make the gun more consistent shot to shot

Kev does a  reg that fits the earlier Rapid 7 models and mk1s, the porting is different ; position and size.
R7 and mk1porting  is meant for restricting constant Hp air, whilst the larger mk2 is for unrestricted flow of lower pressure air.

As I mentioned in the other thread, no reason why you couldn't fill to 230 bar or possibly higher with a reg.
Unless you have a compressor 300 bar could be tricky....well dive cylinder pressure would drop each fill.
Wouldn't fancy it myself, no idea what the SWP of the quickfill is.

Besides the reg you would need an exhaust valve with a larger front port.

All pretty much reversible

another Steve
Title: Re: Mk1 block
Post by: PiL on June 08, 2020, 12:37:37 AM
Thanks for replying Steve, something to get my head around whilst deciding what to do 👍.
Yes, Theoben Rapid System on the block, you are correct 👍
Thanks for your help
Steve
Title: Re: Mk1 block
Post by: Squinty on June 08, 2020, 07:02:07 AM
you're welcome, the other option is to fit a Lane Mk10 external regulator.
I've read the online manual for this a couple of times and I guess it's supposed to be a direct fit as there is no mention of any modifications to the block itself.

No idea how that compares to a inboard reg for consistency and shot count, it has a 250 bar SWP.
Only heard / read about one being fitting and there were some initial set up issues.

But as a stand alone reg/QF unit it does add extra length like the Best Fittings QF.
Title: Re: Mk1 block
Post by: PiL on June 08, 2020, 10:56:41 AM
Cheers for putting up another option, it's all food for thought. I think if I do go ahead I'd want the bottle to go no further forward as it is the same length as a 400cc just narrower.
Thanks again for all the information, I appreciate it 👍
Steve