Theoben Rapid Forum

As it is alsmost imposible to get an Raw factory Quick fill from the Raw importer in Holland. I am waiting since July 2025 on the part. I was looking arround for a machinist that could make them. My regular machinist guy had an medical issue so he could not make them.

Than I found through the forum in Holland a south african machinist that moved to the Netherland and worked in The Netherlands. I contacted him with the quistion if he could make them and the answer was yes.

He made the two V-block and modified the regulator and fast flow housings that I supplied.
He offered coloring the parts with Cerakoted the housingss and the V-blocks and I'm very happy with the results

Before making them He send over some 3d printed examples so I could test fit them and see if there where any problems with the chassis.

For the dutch users on this forum and in need of a machinist in Holland I will post his infor here

https://www.mitchell-precision-sport.nl/

Yep...Been there and done it too....
(https://photos.imageevent.com/scl_electronics/gun/qf/websize/20150515_122233.jpg)
(https://photos.imageevent.com/scl_electronics/gun/qf/websize/image_1.jpg)

Stuart

Wish I could have done that, and had the skills to do so.

But I am happy with these  :D

Well being self taught Machinist......
I Had  a Lot of coaching from Friends I have made over the Years...
You never now what you can achieve until You Try!!

Atb, Stuart