Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: The commercial on February 01, 2026, 09:26:31 PM
Hi all would anyone be able to tell me if a 400cc bottle would fit an mfr with a mk2 stock.
Thanks
There will be @ problems with the 400cc bottle.
1. Fitting under the Factory Shroud... the 400cc bottle is larger in Diameter, so it will hit the MFR shroud.
Unless you remove the barrel and go with a standard barrel and mod...
2. The MFR bottle seals on an O-ring on the depressing pin in the Reg. Due to this, It is larger in Diameter
So the opening on the bottle is larger...
(https://photos.imageevent.com/scl_electronics/gun/air/websize/bottle%20valves.jpg)
So you can fit a MKII reg and use the standard Neck O-ring to seal on the 280cc bottle
HTH, Stuart
Yes if you have a std 16mm barrel & mk2 stock,
all you need then is to find a MFR 18x1.5 Valve to fit the 400cc bottle ??? 8)
https://www.bestfittings.co.uk/shop/fill-probes-adaptors/buddy-bottles-valves/best-fittings-buddy-bottle-valves-theoben-mfr-valve-fitment/ (https://www.bestfittings.co.uk/shop/fill-probes-adaptors/buddy-bottles-valves/best-fittings-buddy-bottle-valves-theoben-mfr-valve-fitment/)
400cc MFR bottle valves from best fittings
Thank you all for clearing that up for me. I would like to do a cal change so will hold off until I decide what way I want to go with it