Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Tacker on November 23, 2025, 04:40:34 PM

Title: Anschutz match trigger
Post by: Tacker on November 23, 2025, 04:40:34 PM
I've done a search and read a thread about some Anschutz triggers fitted to Rapids without the safety catch.
Someone mentioned seeing a Rapid on g'trader without safety which I think I noticed.
Does any one know if the safety catch can be removed (not cut off) or does it have to be a trigger designed for no safety catch?
I'm considering a new stock for the range for my Anschutz Rapid.
I know that the block sits forward like a MK1 but it would be great not to have to notch a new stock.

Title: Re: Anschutz match trigger
Post by: Brooksy on November 24, 2025, 09:53:12 AM
The safety catch can be removed in about two minutes. Pop the E clip off and simply pull it off the pin. The spring will come off with the tension cam, again, another E clip.
Title: Re: Anschutz match trigger
Post by: Tacker on November 24, 2025, 10:16:19 AM
Excellent.
Title: Re: Anschutz match trigger
Post by: Brooksy on November 24, 2025, 10:12:25 PM
If you have any doubts, send it to me. The locating pins may need to be removed to make the fitting a bit narrower.
Title: Re: Anschutz match trigger
Post by: Tacker on November 25, 2025, 08:53:59 AM
Thanks mate
Title: Re: Anschutz match trigger
Post by: Brooksy on November 25, 2025, 08:46:59 PM
1. Remove these three E clips and the safety catch, roller and spring will detach from the trigger unit.
2. Replace the rear E clip after the roller and spring have been removed.