Text only | Text with Images

Theoben Rapid Forum

KevG Lathe work undertaken => kevG section => Topic started by: xjral on August 27, 2025, 03:10:41 PM

Title: MFR push pin disc
Post by: xjral on August 27, 2025, 03:10:41 PM
Hi KevG. 

I am hoping you can help me.   Stupidly, I have managed to damage the brass push pin disc on my MFR (by forgetting to remove the grub screw - you must have seen that a million times!).  Would it be possible to make a replacement for me, please?   

Best,

xjral
Title: Re: MFR push pin disc
Post by: KevG on September 02, 2025, 06:45:31 PM
yes m8 I would give the reg a complete strip down though and give it a good clean inside incase any brass debris as got in from the damaged push pin
kevG
Title: Re: MFR push pin disc
Post by: xjral on September 02, 2025, 07:16:16 PM
Nice one! Thank you.  Could you pm me your details?   

I ended up switching it out for the one in my FAC .25.  So both reg assemblies got a good clean out and re-seal. 
Text only | Text with Images