Print Page - Barrel job

Title: Barrel job
Post by: skagitmonster on August 03, 2025, 07:41:34 PM

Hi kev I've a silco blank I need turning / screwcut / crown etc can you maybe fit it in its for a sub 12 mk2 ...no rush like
If you can drop me a pm please
Regards
Mark

Title: Re: Barrel job
Post by: KevG on August 04, 2025, 10:58:08 PM

Emailed you m8
kevG

Title: Re: Barrel job
Post by: Squirrel 1965 . on October 18, 2025, 10:04:58 AM

Is there a for sale section, as I'm looking for .25.barrel .

Title: Re: Barrel job
Post by: skagitmonster on December 21, 2025, 06:14:06 PM

Quote from: Squirrel 1965 . on October 18, 2025, 10:04:58 AMIs there a for sale section, as I'm looking for .25.barrel .

Buy a blank bud , polygons are good ,choked or unchoked , keep the length as you can use bigger bottles .....if that's your bag
Sm

Title: Re: Barrel job
Post by: skagitmonster on December 21, 2025, 06:28:19 PM

Quote from: skagitmonster on December 21, 2025, 06:14:06 PM
Quote from: Squirrel 1965 . on October 18, 2025, 10:04:58 AMIs there a for sale section, as I'm looking for .25.barrel .
Buy a blank bud , polygons are good ,choked or unchoked , keep the length as you can use bigger bottles .....if that's your bag
Sm

tbh silco ain't bad at all , alpha are v good so are lowthers ... all depends on what your needs are

Theoben Rapid Forum

KevG Lathe work undertaken => kevG section => Topic started by: skagitmonster on August 03, 2025, 07:41:34 PM