Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: stefan on June 02, 2020, 08:37:47 PM

Title: theoben rapid mk2 video ?
Post by: stefan on June 02, 2020, 08:37:47 PM
evening all  does any one know of any videos showing a full strip down of a mk2 ? as i wouod love to learn know how to do my own service on it and learn more about it  as in polish this dont polish that  ect ect ect  thanks all stefan
Title: Re: theoben rapid mk2 video ?
Post by: KCE on June 02, 2020, 09:02:00 PM
Hi Stefan.

Take a look in the Technical section and the airgun data section on here you will learn a lot from there as to what you need to know about your rapid.
Regards KCE.
Title: Re: theoben rapid mk2 video ?
Post by: stefan on June 02, 2020, 10:31:10 PM
cheers
Title: Re: theoben rapid mk2 video ?
Post by: Squinty on June 03, 2020, 07:42:09 AM
there's not much to the actual strip down, they really are that simple
this is with the earlier sporter trigger unit... mk4 is two pins

Doesn't get any harder than this.....

https://www.jimmiedeesairguns.com/guides/service-guides/theoben-rapid-mkii-service-guide/a-service-guide-for-the-theoben-rapid-mkii/

what to polish...?
the hammer.... polish not sand!
you can polish the hammer spring ends assuming that they are well finished to start with.
No need to polish the bolt... really... just the tiniest amount of molybdenum sulphide grease

Title: Re: theoben rapid mk2 video ?
Post by: PiL on June 07, 2020, 11:29:11 AM
Thanks for posting the link to that tutorial, Squinty 👍. Even though mine is a mk1, the detail and the pics put up there-in were very informative, often wondered what the blanking seal plate in the bottom of the block was for 👍.
I was going to ask on here, if I changed where the bottle valve goes into, to a regulator, could I fill my carbon bottle to 300 bar. Going by the tutorial, if I read it right, other work on the block would need to be done, is that right?
Title: Re: theoben rapid mk2 video ?
Post by: Squinty on June 07, 2020, 12:29:37 PM
I don't know how much the regs will take, RAWs go 250 > 300.
I asked Kev if I could go to 250bar...not that I need to
He said shouldn't be problem but he only fills his FAC to 230.

Block mods depend on the age but non-reg blocks have different porting as they run higher inlet pressures

Title: Re: theoben rapid mk2 video ?
Post by: KevG on June 07, 2020, 08:36:00 PM
The regs should work fine upto 250 bar.but not the early circlip type.200 bar for those
KevG
Title: Re: theoben rapid mk2 video ?
Post by: jps on June 15, 2020, 04:19:08 PM
Quote from: KevG on June 07, 2020, 08:36:00 PM
The regs should work fine upto 250 bar.but not the early circlip type.200 bar for those
KevG
That's good to know as the reg in my late Mk1 is the early cirplip type