Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: MartinTTR2 on May 14, 2025, 04:07:54 PM

Title: MFR Pin Disk from KevG
Post by: MartinTTR2 on May 14, 2025, 04:07:54 PM
Right... among my past lives are about 5 years as a self employed turner and around 20 years teaching Engineering & Technology to adults, so I think I know what I am talking about.

If KevG tries to tell you he's not an engineer... don't listen to him.
He has has just sent me the cutest little Pin Disc for my TTR2.

I got the digital callipers out (to be expected) and ran a critical eye over it. He even pre-greased the O-Rings. A very nice little job indeed.

So "full marks and Saturday off" as we used to say.

My own lathe contactor is fried - I can fix it in time but Kev turned the job around in a couple of days.

Thanks very much KevG.
Title: Re: MFR Pin Disk from KevG
Post by: Kernal on May 14, 2025, 06:23:06 PM
Please do remember this is KevG`s forum and he is here to help everyone passing on your good words will be much appreciated!

Thankyou

 :)




Title: Re: MFR Pin Disk from KevG
Post by: KevG on May 14, 2025, 09:05:00 PM
thanks for the kind words martin  very much appreciated m8.hope it does the job for you.
kevG
Title: Re: MFR Pin Disk from KevG
Post by: MartinTTR2 on May 15, 2025, 06:41:40 PM
No problem KevG.

It's already screwed in. Pin drive holes lined up perfectly as well.
You've added better support for the o-ring than the original as well.

Have you ever tried Viton o-rings?

A little tougher than the black Nitrile ones but softer and definitely "flow" better than the Urethane ones that are typically sold as "upgrades".

All the best.

MartinTTR2
Title: Re: MFR Pin Disk from KevG
Post by: KevG on May 15, 2025, 07:59:38 PM
always just used Ni90,viton maybe worth a try though,yes the so called upgrade ones are not that good.
kevG