Text only | Text with Images

Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Squinty on July 16, 2024, 10:42:16 PM

Title: What? How?
Post by: Squinty on July 16, 2024, 10:42:16 PM
Always have a good look on Eblag for Rapid bits.
Saw an S-type stock and flicked through the images.
The back is slotted and well it has a QF cut out which is a shame.
Then I got to the last image in the gallery..
Title: Re: What? How?
Post by: rye_1977 on July 16, 2024, 10:51:55 PM
Maybe it was drilled and tapped for a pressure gauge 🤷
Title: Re: What? How?
Post by: Squinty on July 18, 2024, 11:03:41 AM
Quote from: rye_1977 on July 16, 2024, 10:51:55 PMMaybe it was drilled and tapped for a pressure gauge 🤷

on the thinnest part of the block?
Title: Re: What? How?
Post by: rye_1977 on July 18, 2024, 04:01:58 PM
Quote from: Squinty on July 18, 2024, 11:03:41 AM
Quote from: rye_1977 on July 16, 2024, 10:51:55 PMMaybe it was drilled and tapped for a pressure gauge 🤷

on the thinnest part of the block?

It certainly wouldn't surprise me. I've seen alsorts over the years....I'm sure it's been done before. Looking where it's situated I'd probably say so..
Title: Re: What? How?
Post by: Ca_Varminter on July 18, 2024, 04:21:19 PM
 I think the Person screwed up their Measurement!!!
And cut a Very Clean hole in the Wrong Place!!

 :o  :o  :o
Stuart
Title: Re: What? How?
Post by: rye_1977 on July 19, 2024, 01:11:04 AM
Quote from: Ca_Varminter on July 18, 2024, 04:21:19 PMI think the Person screwed up their Measurement!!!
And cut a Very Clean hole in the Wrong Place!!

 :o  :o  :o
Stuart

Yes stuart.....it looks a good inch or so off! 🤪🤣

Rye
Text only | Text with Images