Theoben Rapid Forum

I have a old s-type stock butt non of my stuff fits in the rail. Most rails I have are UIT type butt the do not fit.

Does someone know what should fit there

I believe it uses Anschutz T-slot accessories....
I never owned or held one...
You will need to measure the slot width to be sure!!

Good Luck,
Stuart

Anschütz and UIT should be the same and those won't fit. Could it be freeland rail system.

Here is a the specs of both T-slots....
(https://photos.imageevent.com/scl_electronics/gun/misc/websize/T-slot.JPG)

HTH,
Stuart

Just measured the rail, its neither of those two.
           UIT      s-type
Opening   10 mm      11 mm
Height     4 mm       5 mm
Width     13 mm    14.5 mm

Did theoben had it own rail type?

They might of made it themselves....
But but looks of it the Anschutz t-slot accessories would probably would work....


Stuart

Well this may be a little late in coming.....
I Just found I sling stud the WILL fit the S-Type rail!!!
It is from RAW...
According to their RAW's site... They are using the UIT RAIL!!

(https://cdn3.volusion.com/jnsgp.vlysg/v/vspfiles/photos/RW-AC-704055-2T.png)

Quote from: RAW

Sliding rail stud for attaching a bipod to any rifle fitted with a UIT style rail, all Rapid Air Weapons rifles fitted with a front rail and Theoben S type rifles. Larger Securing screw than other manufacturers and a steel locking ring securing the stud, this is designed for strength and longevity. Slide Made from Aluminum and stud made from Steel.

HTH,
Stuart