Theoben Rapid Forum
Everything Technical About Rapid => Technical => Topic started by: angrybear on April 18, 2023, 06:56:50 PM
accurate afaik
Rapid Bolt & thread sizes.docx
just in case the docX won't open...my PC says no.
Rapid Thread Sizes
Early Mk1???
Hammer adjuster: 1/2" BSP?
Barrel location grub screw: 2BA
Front scope mount: 2BA
Rear scope mount: 2BA?
Barrel clamp bolt: 2BA
Valve retaining grub screw: 4BA
Cocking bolt: 1/4" UNF 28tpi
Valve spring cap: 3/8" BSP?
Bottle holder: 3/8" BSP
Front trigger guard: 1/4" UNF 28tpi
Rear trigger guard: 2BA
Hammer pip: 2BA
Bolt gate: 2BA
cocking dog 4ba x 3/16
Gamo trigger sear adjuster M3x 8mm
MK2 / New MK1???
Hammer adjuster: M20 x 1mm pitch
Barrel location grub screw: M7 x 0.75mm pitch
Front scope mount: 2BA
Rear scope mount: 2BA
Barrel clamp bolt: 2BA
Valve retaining grub screw: M3 (5mm long)?
Cocking Bolt: 1/4" UNF 28tpi?
Valve spring cap: 3/8" BSP
Bottle holder/regulator body: 3/8" BSP
Bottle external thread: 1/4" BSP
Front trigger guard: 1/4" UNF 28tpi?
Rear trigger guard: 2BA
Hammer pip: 2BA
Bottom access plug: 1/4" BSP
Bolt guard top screw: M3 (8mm long)
Bolt guard bottom screw: M4 (6mm long)
Cocking dog M3x5
Other sizes
Silencer thread: 1/2" UNF 20 tpi
Bottle external thread: 1/4" BSP
200cc bottle internal thread: M14 x 1.5mm pitch
280cc bottle internal thread: M14 x 1.5mm pitch
400/500cc bottle internal thread: M18 x 1.5mm pitch
Probe adjuster screw: 2BA (5/8" long) grub screw
Probe locking grub screw: M3 (5mm long) / 2BA (3/16" long)
Hi guy`s i`ve just added the attached file by angrybear to our downloads section if you wish to go check it out,
Have a great day.
;)