Theoben Rapid Forum

Good day is there a picture or a drwg of all the parts in the early mk2 trigger.

I can only fi d a picture from Jimmy's page.
Butt that one is not complete, I have an extra spring in mine.

Well Theoben made 2 styles of the MK II Sporter trigger.
The on in your diagram was the initial version.
Using just a Sear Plunger.....

The second version employs a hammer sear lever with the plunger...
Also... Some had that second spring that pressure on the lever!!!!!
Here is the photo of the parts..minus that ever spring though
(https://photos.imageevent.com/scl_electronics/gun/air/websize/sporter%20trigger%20parts.jpg)
here is the spring, seen in the cutout slot..
(https://photos.imageevent.com/scl_electronics/gun/air/websize/side-view_1_.jpg)
a bottom photo with the spring retaining plate removed..
(https://photos.imageevent.com/scl_electronics/gun/air/websize/Bottom-view2.jpg)
Finally my diagram of the Sporter setup with 2 springs and lever
(https://photos.imageevent.com/scl_electronics/gun/air/websize/mkIIper20sporter2.jpg)

Stuart

Thanks for the information.
I indeed have an extra spring that I could not see on som drawings.

Brgds
Herman

Glad I could help you with some info.....
If you need a bit more... How to adjust the trigger..here another post of mine..
https://rapidforum.co.uk/forum/index.php?topic=275.0

Good Luck
Stuart

they also did a first version were there was no lever just the piston sear that was in direct contact with the hammer.this was soon improved on as the piston could become sticky in its bore at higher powers.
kevG