I have a couple of mk4 trigger that are damaged, is there anywhere that sells triggers. impact won't reply.
If it's just a blade, then Rowan engineering do nice, adjustable ones. Anything else, Dr. bob may be able to help. He had a run of mk4 trigger units manufactured a while back.
what trigger parts are damaged, apart from springs there is nothing that should fail.
kevG
Quote from: Andycoup on January 14, 2023, 02:59:47 PM
If it's just a blade, then Rowan engineering do nice, adjustable ones. Anything else, Dr. bob may be able to help. He had a run of mk4 trigger units manufactured a while back.
May not be right on this... Bob's were modelled on Chip Brown's modified sears?
I believe that I have one of Bobs, came on an 'untouched' block I bought a while ago and looked rather new. ::)
The sears were oil-blacked and had a slightly different shape to my other mk4.
He would be the man to callI have no idea if he has spares or if individual sears are interchangeable.
Quote from: Ben Dover on January 14, 2023, 02:47:22 PM
I have a couple of mk4 trigger that are damaged, is there anywhere that sells triggers. impact won't reply.
I got a hold of impact last week they have no triggers or parts.
Quote from: KevG on January 14, 2023, 03:36:07 PM
what trigger parts are damaged, apart from springs there is nothing that should fail.
kevG
The blade where the screws are. I've seen a few go.
But also handy info if you get a block with no trigger included. They seem a little thin on the ground.
OK....since it isn't a High stress part like the sear or sear strut..so no harden steel needed..
That part is easy to make...... well a modified one....
Here is the one I have made for the Mark 4 trigger.... it uses the Anschutz trigger arm.
(https://photos.imageevent.com/scl_electronics/gun/air/websize/Mark4-tirg1.jpg)
(https://photos.imageevent.com/scl_electronics/gun/air/websize/Mark4-tirg2.jpg)
Here is the milling process..
(https://photos.imageevent.com/scl_electronics/gun/air/websize/2012-02-14_14-59-45_679.jpg)
(https://photos.imageevent.com/scl_electronics/gun/air/websize/2012-02-15_13-31-45_250.jpg)
So Good luck!
Stuart
I was looking at original type parts.
Here's a blade from rowan engineering, I think there a nice blade but the original curly blade is also very nice but just can't seem to to get them now unless you know someone from states who will post to you.
For OEM trigger.....
RAW still sell them... I am not sure since the change of ownership how to purchase it...
Another possible contact ver here... Martin Rutterford
He open a new Business,
Airguns USA: https://airguns-usa.com/index.php
he states he sells parts for the Rapid...
Good Luck,
Stuart