few bits in for my next build, sourced from a local-ish Rapid nut 😁
GSX100 stock
Theoben 120 tube
KEV G reg
more bits on the way and a few more to find or order 🤣
That sounds like a nice lightweight outfit well on its way.
It is endless what you can build today from parts.
keep us updated when project id finished.
Regards kev.
Superb, you will love it. I've got a couple this way and really like them :)
Looking forward to watching the build progress 👍
made up 😁
managed to get my old MFR block back that was part of my original GSX 100 hybrid build 👌
truly a christmas wish come true
just need a barrel clamp, .20 probe and circlip for it
should be a cracking when built up.
KevG
Hi kevG to are last phone call about my valve with I will have done when xmas is over I got the 16inches barrel with the vortex silencer if I had the dr bob qwick fill is it going be tight up to the silencer and if so would it be better to have the 19 inch barrel and would my 22 be ok with that i.e it still shoot ok
no it should be fine,when you say valve do you mean regulator
KevG
Yes m8 what we talked about on the phone get xmas out of the way and get you sort on out please
not sure how my thread got hijacked 🙄
anyway, couldn't resist putting a few bits together earlier
nice stocks those,should look well when all put together
KevG
heres one of mine it as the hugert shroud
kevG
lovely Kev mate, my original one had a hugget shroud, i remember you doing a bit of a double take when i showed it you saying it looked just like yours 😂
Hi Phil I see you are as bad as Me, you getting a bit too old to hold the FT Rifles any longer, looks like your bits are starting to roll in, cheers Blue.
so, little update
i lost my mum at the beginning of january which was hard, so my guns took a backseat
.20 barrel via Brooksy and my old Huggett shroud back to mod
didn't have any proper stock bolts for the IA stock, so sourced some sexy stainless ones20230504_130544.jpg20230504_130554.jpg20230504_133314.jpg20230426_155323.jpg
Will look good with the shroud fitted 👌