Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Squinty on December 05, 2022, 08:33:02 AM
Question came up on the FB Rapid group....when did Theoben start to fit the AT plug?
As far as I know the industry adopted anti-tamper devices circa 1997 which would coincide with the restricted flow sub-12 bottle holder on late R7s and mk1s.
Were Mk2 hammer adjusters 'plugged' from the start? Or later on when the VCR act came in?
part 2 S-Type.....just being picky?
I was looking on t'internet in regards to the AT and found an old blog that covered servicing an S-type. Chap said that he removed the AT.
But although the gun in the pictures had an S-type stock it had a mk2 /MFR block with angled front.
I was under the impression that the S-Type was built on the latest 2005 square ended block with S-TYPE milled on the l/h side?
s type did originally have angled block and AT came in around 2004 /2005 and originally made of plastic.the mk1 bottle adapter changed like you say around 1997 but was changed to prevent people choping the back threads of to increase pre chamber capacity, which was very dangerous.
KevG
Cheers Kev, a font of knowledge as always.
Guessing that the model was launched around the same time that the block was changed.
Besides a few adverts this was the only S-Type bumpf I could find, no date as usually found on spec sheets - later square front block.
https://www.diamanco.gr/Upload/S_TYPE_SPECS_ENGLISH.pdf