Print Page - Mk1 mfr build

Title: Mk1 mfr build
Post by: Daztilley on October 23, 2022, 07:09:15 PM

Had an early mk1 .22 block and a 12" .22 barrel with bucket boy shroud ...... thought it would be an idea for a mk1 / mfr build......
Using a MFR stock and a mk1 kevg mfr type regulator. It all went together very easily and set the reg at 100 bar as the barrel is quite short.

Pard 008 fitted on a Dr Bob weaver rail and zb Pro mount

Title: Re: Mk1 mfr build
Post by: KevG on October 23, 2022, 09:42:43 PM

very nice Daz.looks a handy tool.
KevG

Title: Re: Mk1 mfr build
Post by: Daztilley on October 23, 2022, 09:45:48 PM

It's really good being a carbine length Kev - might be getting a touch of hammer bounce ...... may be in touch for a double tap to sort that out 👍

Was firing it at the range and all you could hear is the hammer hitting the valve - then the smack of pellet hitting the spinner 😃

Title: Re: Mk1 mfr build
Post by: KevG on October 24, 2022, 10:18:46 AM

may need reg turning up slightly with it being a shorter barrel Daz.
KevG

Title: Re: Mk1 mfr build
Post by: Daztilley on October 24, 2022, 03:57:02 PM

Yep was thinking that kev , so set it at 100 bar as its .22 . Just trying to get a sharp blast on firing without using too much hammer spring.

Title: Re: Mk1 mfr build
Post by: saddler1980 on October 26, 2022, 08:57:30 PM

lovely little one that is Daz

Title: Re: Mk1 mfr build
Post by: Kernal on October 28, 2022, 04:45:57 PM

Nice how you`ve done that Daz sometime even i miss the normal look of a pre-charge.

:)

Title: Re: Mk1 mfr build
Post by: The Robin on October 30, 2022, 01:06:15 PM

Looking good Daz 8)

Theoben Rapid Forum

Gallery => Gallery => Topic started by: Daztilley on October 23, 2022, 07:09:15 PM