Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: GB2017 on September 21, 2022, 07:07:08 AM

Title: Reg Pressures
Post by: GB2017 on September 21, 2022, 07:07:08 AM
Morning All

just reaching out for some info please, what reg pressures do people run for the different calibres in "standard" sub12 setups. When I had a leshiy I had it at 95 for 177, so just wondering the differential for 20 and 22

Thanks in advance

Geoff

PS By "standard" I mean generic i.e. no long / short barrels
Title: Re: Reg Pressures
Post by: Squinty on September 21, 2022, 08:15:22 AM
Kevs tried and tested settings

177    1350psi /93bar     (factory 1500psi )
20     1250psi  86bar     (1450)
22   1000-1200psi 68-82bar (1200)







Title: Re: Reg Pressures
Post by: GB2017 on September 22, 2022, 05:50:04 AM
Quote from: Squinty on September 21, 2022, 08:15:22 AM
Kevs tried and tested settings

177    1350psi /93bar     (factory 1500psi )
20     1250psi  86bar     (1450)
22   1000-1200psi 68-82bar (1200)

Thanks for that, interesting the factory settings were a lot higher
Title: Re: Reg Pressures
Post by: Squinty on September 22, 2022, 11:49:02 AM
I guess 20 years ago 50% more shots (than a mk1) was enough of a selling point?

I run my 177 at 1375psi /95bar with a 19" barrel, lower ie 90bar uses more air.
Title: Re: Reg Pressures
Post by: KevG on September 22, 2022, 12:10:35 PM
done loads of testing over the years and found 1500 psi to be the best setting for .177 and 16 inch barrel. you can actually run as low as 1100 psi but shot count/accuracy/consistency suffers.can sometimes make the muzzle noise loader and amplifies hammer bounce.
bounce
KevG