Hi all, ive been thinking of getting another Rapid, this time a sub 12ftlbs model that i could use where my FAC rifle is not practical.That was until i saw the prices they're attracting. So would the following scenario be practical or even legal?
If i got another slot for FAC air, could i then buy a cheap FAC rapid ( for as little as £300 in some cases), detune down to bang on 12 ftlbs and use as needed?
Yup
No minimum power for fac , it would still obviously still always be considered an fac rifle though
It's actually now prohibited under the Firearms act, caught up in the rules for powder burners, I found it by accident.
Once section 1, always section 1, unless officially deactivated or turned in to a smoothbore section 2 (IIRC)
You can't take it off ticket but you can if you wish turn it down to sub 12 and shoot it ,but even if it is running sub 12 it's still classed as a fac rifle if the boys in blue run a number check
Thanks all, looks like thats the way forward.
So the next thing i need to know is what should i be looking for in a starting model ? Mk1's seem to be at the bottom end of the market but iirc these we not regulated so should i be looking at a MK2?
I think Kev G does a reg for MK1's should you require one, otherwise it's largely down to looks &/or price.
From a pure Mechanical Viewpoint.
MkII.....with Mark 4 trigger. Far superior to the gamo..
It also has a Reg....just needs to be de-tuned to 12 fpe....
Just an opinion from across the Pond,
Stuart
Would the barrel have to be re ported?, I think so.md
Quote from: Ca_Varminter on August 05, 2022, 03:52:13 PM
From a pure Mechanical Viewpoint.
MkII.....with Mark 4 trigger. Far superior to the gamo..
It also has a Reg....just needs to be de-tuned to 12 fpe....
Just an opinion from across the Pond,
Stuart
This is what i have atm @35ftlbs. Its tidy as fnck and i'd be well chuffed if i could end up with something like this again.
I sent of for my variation today, the last one took about a month.
Quote from: Mickyd on August 05, 2022, 04:12:59 PM
Would the barrel have to be re ported?, I think so.md
Back when Theoben used to offer the de-tune service, they specified a barrel change down to 16" was required.
I am no expert in this type of Rapid Work....
I time for Our Super-Hero KevG and his sidekick- The Rabid Fox!!!!!!!!!
Stuart
Rapid 7 should be ok on the porting.
On FAC there's no need to worry about being over, so a shorter hammer spring and a longer hammer pip would suffice even if its has to run at 14-15fpe to get consistency.
if you stayed with longer barrel and fac port you would have to fill to a much lower pressure as the curve would be terrible also lock time would be much slower to keep power down.bottle adapter would also need choking down
KevG
Id be looking at a much shorter barrel i think, probably 16 inch?
Got my variation today so i'm looking for a cheap MK 1/2 .22 FAC model to start on. ;D