Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: nevadacowboy on June 15, 2022, 10:37:21 PM

Title: Gamo Trigger adjustment
Post by: nevadacowboy on June 15, 2022, 10:37:21 PM
I have a 1997 Mk1 rapid with a gamo trigger that I just don't get on with, the pull weight is far too heavy for my liking. Is there any way the pull weight can be made lighter? If I can't sort this out soon the gun will find itself in the for sale section.
Title: Re: Gamo Trigger adjustment
Post by: Ca_Varminter on June 15, 2022, 11:21:20 PM
This sounds like a job for KevG....
He the expert on the Gamo Trigger.....

Good Luck,
Stuart
Title: Re: Gamo Trigger adjustment
Post by: Squinty on June 16, 2022, 10:44:48 PM
the pull can depend on the the top   middle sear and trigger return springs,
Top middle sears seem to be the same but return springs..some are light 0.6-0.7mm others can be 1mm - particularly if they have been rebuilt with a generic donor.

The grub doesn't adjust the pull weight as such, it adjusts the sear engagement.

Usual method is to bend the springs to reduce tension or fit a lighter spring, I think Kev said that he has some lighter returns.

Other issue is the length of pull, as the Gamo is actually a single stage trigger most of it is take-up. The vague 'first-stage' is just the return spring.
The trigger pin ( 15l ) can be bushed, either a delrin disc or micro bearing, i/d 5mm x 8mm  2.5mm wide.
There are a few how-to videos on YouTube.
Once the excess travel has gone the pull can be hair-trigger short, if anything I had to back off the grub.
I didn't find it necessary to make the trigger lighter once I'd stopped anticipating / searching for the break.