Hi all, I've recently purchased a carbon fibre buddy bottle from best fittings with one of their valve onit, since putting it on the gun and taking it to the field I have been missing alot of rabbits!!!
My scopes are zeroed at 50 yards, so 25 yards is a mil dot above the centre cross with my set up, that was with the 400cc alloy bottle. As said before once putting the cf bottle on my zero is completely off and I cant seem to zero my scopes properly because I get alot of flyers.
One thing you can try is put back on the 400 bottle and see if you have same probs to start with.
If that is ok then there lies a prob with new bottle so can start to sort out from there.
Regards kev.
you have a carbon sleeve on the barrel plus a bottle clamp, chances are the clamp, is coming into contact with the barrel and sleeve
KevG
Hi Kev I didn't end up keeping the carbon shroud on the barrel because of that reason, I have a good 1.5/2mm clearance from the clamp to the barrel
Just a process of elimination, so I'd also try moving the bottle clamp right back to the shoulder as far as it will go (which might change any resonance) then try without the mod, with the mod but without the bottle clamp, resting the bottle on a bag, then with the stock rested not the bottle, then with a different bottle etc
Also keep in mind the Basics of Accuracy......
Barrel....Clean,Tight, and no unintentional pressure applied to it!
Scope ....Tight
Stock ....Tight
BTW.... KCE is right... If you have changed something, and your accuracy suffers....
Put things back as it once was, to see if the problem is eliminated....Just a process of elimination...
Good Luck,
Stuart
Thanks people will take it all into consideration and have a play about will let you know what the results are