Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: Craigash on June 03, 2022, 04:33:31 PM

Title: Power adjustment
Post by: Craigash on June 03, 2022, 04:33:31 PM
Hi everyone.  I just took my recent purchased rapid 7 mk1 to the range. Shoots spot on at 35. Fx mk2 chrono saying 13.7 with jsb 15.89
Is it a big job to drop the power to sub 12?
Title: Re: Power adjustment
Post by: Aggy on June 03, 2022, 04:46:33 PM
Wind out the adjuster on the back of the hammer spring
Title: Re: Power adjustment
Post by: Craigash on June 03, 2022, 07:12:36 PM
Is that under the large stainless steel bung?
Title: Re: Power adjustment
Post by: Ca_Varminter on June 03, 2022, 07:37:09 PM
Hammer Pre-Load Adjustment screw is located under the Bolt body...
(https://photos.imageevent.com/scl_electronics/gun/air/websize/hammer-adj-screw_1_.jpg)
Depending on the age of your rapid....
It may be under an "Anti-Tamper" plate!!!!!!

Good Luck,
Stuart
Title: Re: Power adjustment
Post by: Kernal on June 03, 2022, 07:57:48 PM
What about the power curve on the mrk 1 without the reg that is,....would he not need to take this into account too.

:)
Title: Re: Power adjustment
Post by: Craigash on June 03, 2022, 08:04:45 PM
That pic is exactly what it looks like.  It's 2002 model. But it looks like somebody has already been in there. The hex is a little chewed.
Title: Re: Power adjustment
Post by: Aggy on June 03, 2022, 08:14:35 PM
Someone has been playing if it's chewed up ,it's a fairly chunky part easy to source one and replace it , get yourself a chrono
Title: Re: Power adjustment
Post by: Ca_Varminter on June 03, 2022, 08:22:07 PM
Quote from: Kernal on June 03, 2022, 07:57:48 PM
What about the power curve on the mrk 1 without the reg that is,....would he not need to take this into account too.

:)
Hi Kernal.....No...
Since you boys live in the shadow of Under 12 ft-lbs.
And his guns is a little hot, so he needs to adjust the power DOWN!!
To my Understanding, the UK Law is "absolute"
So under NO circumstance may your Gun  shoot Above 12 ft-lbs
No matter where your gun is on it's Power-Curve......

Stuart
Title: Re: Power adjustment
Post by: Craigash on June 03, 2022, 09:22:28 PM
Down is where I want it to go. I have removed the action from the stock until I get chance to do it. I have a fx mk2 crono to make sure all my air guns are legal.
Title: Re: Power adjustment
Post by: KevG on June 03, 2022, 10:21:41 PM
with the mk1 if its standard and in good state of tune with 180 bar fill pressure it needs to be doing 10.8 ti 11 ftlbs. power will creep up to around 11.7 ftlbs on the sweet spot then back down some guns can differ regarding the fill pressure also some gauges can read slightly different  so fill pressure needs to be checked on each individual gun.
KevG