Theoben Rapid Forum
DrBob`s products & parts => Dr Bob's Section => Topic started by: jackrooz on May 25, 2022, 11:03:13 AM
am in need of the above the safety switch as my one doesn't engage properly and has worn down it looks like
The safety for the Mark 4 is very simple...
It is a hook with a serration on top for the detent spring to engage...
(https://photos.imageevent.com/scl_electronics/gun/air/websize/Mark4_1_.jpg)
If it not engaging... or won't stay engaged..
It maybe it is out of adjustment..
If someone messed with the trigger, shorten the 1st pull..
This could make tough to engage, or even make non-operational!!
If you want to try....
here is my Tech post on how to adjust or reset your Mark4 trigger
https://rapidforum.co.uk/forum/index.php?topic=272.0
Good Luck,
Stuart
Possible that it's been over adjusted or wrongly set as Stewart has already mentioned.
If you really really don't want to reset the 1st & second stages...you could modify the dog that the hook engages on.
The ones on both of mine were the rattiest looking grub screws going. I replaced both with some new dog-end screws.
Still means stripping the trigger but at least you get to find out what's causing it.
Ratty old grubscrew circled , best to screw in to remove as threads on t'other side are probably chewed up.
Here is another view of the parts...
(https://photos.imageevent.com/scl_electronics/gun/air/websize/Mark%204%20Safety3.jpg)
Good Luck.
Stuart
having got inside the unit it looks like the hook is worn and the grub screw worn so have replaced the grub screw and used a file to increase the hook slightly and we back working lovely