New seals and clean while it's in bits
Nothing to it...
I do this to all my Rapid every year...
Remember use only Molykote or silicone scuba grease on your O-rings!
Have Fun,
Stuart
Hi Stuart will ordinary silicone grease be okay, or bisley gun grease?
Thanks Brad
Well Molykote, Scuba silicone, and Super-Lube grease are all non-flammable...
Safe to be used in High Pressure Air...
Not sure about "standard" silicone or bisley grease.
Just make sure there is no petroleum products used....
Can Lead to an unpleasant explosive event!
Stuart
Hi Simonoxo
I have some molykote here you can have some for free it will last you for years.
I'm not far from you about 20 mins in car.
Regards kev.
Yeh I'm using bisley gun grease :o should I not be!? 🙈 it's not back together yet I'm just waiting on few bits before I finish it off
Quote from: Simonoxo on May 25, 2022, 02:46:34 PM
Yeh I'm using bisley gun grease :o should I not be!? 🙈
No.......
(https://media.giphy.com/media/XUFPGrX5Zis6Y/giphy.gif)
I had a member on the old AirgunAdvice site...
He was about using molybdenum grease in his stirrup pump.
I told him to stop, and use the recommended grease by Hill's!
His next post showed his pump brass adapter had "sheared off"...With a POP!!!
Well he reached a High enough temp and pressure for it to Diesel..
So clean off your Rapid receiver of any residue of the grease in any area in contact with High Pressure Air!
Stuart
That grease you are about to use is for springers not pcp air kits.
I worked on an HW77 some years ago that came to me it was dieseling very bad and had burnt the piston head almost away due to this grease.
Regards kev.
All inners have been in white spirits I was just gonna use that to seat O rings 😅
Quote from: KCE on May 25, 2022, 07:05:30 PM
That grease you are about to use is for springers not pcp air kits.
I worked on an HW77 some years ago that came to me it was dieseling very bad and had burnt the piston head almost away due to this grease.
Regards kev.
Hey Kev!
You still use molybdenum grease on the piston seal... But Very Sparingly!!
Rebuilding my HW80 and Theoben Gas Pistons rifles
I just used a slight smear behind the parachute seal lip!!
By the sounds of it, they shoveled it on!!
Cheers,
Stuart
Hi Stuart I agree just a tad and rub off is all that is needed,
This one was coated all the piston seal the piston and the main spring had so much on it was hard to see the coils.
Regards kev.