Theoben Rapid Forum
Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: smithy123 on May 08, 2022, 03:17:15 PM
Hi all, can anyone shed any light on derelin pins and the best way to polish one up? I have Air coming out the porting in the barrel which is making me think that the derelin pin isn't seating right it was fine last night then this morning re stripped it and it's not holding air when rebuilt!
Thank in advance
I assume you mean the Delrin Valve-body and the main valve stem..
You will need to pull the valve assembly out.
Inspect the sealing area on the Delrin(Acetal) valve-body.. for debris, nicks or scratches
(https://photos.imageevent.com/scl_electronics/gun/air/websize/sealing-face.jpg)
For minor damage you can use very fine sandpaper and a little polishing compound on a rag..
Chuck the Valve-body in a drill and spin it up to polish!
Also check the valve-stem is straight too!
Finally check, the large O-ring/s on the Valve-body for any damage... lube it before when you reassemble..
Also clean the O-ring seal surface in the Rapid receiver. Make it is free of any debris and dry lube!!
Good Luck,
Stuart
If you need them new valves and stems are available from @DrBob and they come with all necessary o rings.