Theoben Rapid Forum

Theoben General Chat Area => Theoben Rapid Discussion => Topic started by: nevadacowboy on March 18, 2022, 10:44:38 AM

Title: O rings on exhaust valve tails
Post by: nevadacowboy on March 18, 2022, 10:44:38 AM
I recently purchased a new valve body and titanium stem from Ben Taylor of Theoben fame. On receipt of said valve I noticed there was no o ring on the valve body tail. I queried this with Ben and he told me that early rapids with the stainless steel valve had a countersink machined into the receiver to accept the valve tail o ring. Later models with the delrin valve body did not have the countersink and it was not required to fit an o ring.

Every valve body I have ever seen has had a o ring on the tail so it was a surprise to find out that the o ring is not required.

Some of the more knowledgeable members on here may already know this but I thought it was worth sharing.
Title: Re: O rings on exhaust valve tails
Post by: KevG on March 18, 2022, 11:48:23 AM
yes its correct what ben says about the older blocks,but same as you always known all valve bodies to have the tail oring.what I have found sometimes in rapids with out this oring can make a popping noise if this oring is not fitted.
KevG
Title: Re: O rings on exhaust valve tails
Post by: nevadacowboy on March 18, 2022, 01:47:30 PM
My reply from Ben.



Wow, that takes me back😂
They havnt had an O seal on that end since the old stainless valve, the delrin valve doesn't need one, if one is fitted the valve body will move up and down as it crushes the O seal as there is no place for it.
You Rapid is regulated I hope?
Title: Re: O rings on exhaust valve tails
Post by: Ca_Varminter on March 18, 2022, 03:09:30 PM
Wow.....
That is the first I have heard of That!!
All my Export/FAC, and the one from Theoben USA
have a Countersunk area for the Tail O-ring!
(https://photos.imageevent.com/scl_electronics/gun/air/websize/20210620_124934.jpg)

Stuart
Title: Re: O rings on exhaust valve tails
Post by: angrybear on March 18, 2022, 06:57:55 PM
I've just checked my spare MFR block & that's got the O ring recess,
I'm not going to open the others just to check, but the delrin valve with bronze filter removed from my 2010 FAC MK2 has an O ring fitted  :-\