I do love my Rapids, but sometimes they can be the most frustrating things going.
Having sorted my probe blow back issue a quick chrono check shows 786 fps near as damn it 22 fpe :o :o
so Reset the reg from 85 down to 80bar drops it to 735 fps,
Check the hammer pip length, it's a bit short so fit the longest I've got, 713 fps,
Out with the springs,
same length but softer drops it to 680 fps,
I've got 4 shorter springs, the first heavy goes up again 692 fps
The second drops to 660 fps, (15.4 fpe)
third down to 536 fps, (10.2 fpe)
fourth 517 fps. (9.5 fpe)
Having run out of time I decide to fit the 10.6 fpe spring,
for some reason I also decide to swap the spring cap,
last chrono check & suddenly it's down to 420 fps,
so go back to the spring that was 660 fps and with the new cap it's 582 fps 12.03 fpe
How the hell does a change of the spring cap alter the muzzle energy by 3.4 ftlb ???
more preload - either - longer. cap or the recess in the cap isn't as deep or is narrower than the guide which won't drop in
Been there with my mk1 .20, was built up from a bare block by the previous owner.
The full monty.....
Bolt handle thread too long,
cocking dog binding on hammer,
dog screw locking on adj pin,
hammer cap/guide different sizes, twangy TRRobb springs,
w*nky probe,
standard valve c/w mfr cap,
wrong porting for reg
trigger rebuild,
Block wouldn't sit level in the stock as it was for a late mk1 with mk4 trigger.
Took me a day of going around in circles to put right
repairing Rapids is like ?
(https://i.imgur.com/xcZKwPd.jpg)
Ah, Swindon.
I never had any problem with the magic Roundabout.
Never been to Swindon :D
but its a more descriptive picture than Hemel.
Like a Rapid dead easy to get around but so many directions to take.