As above, they are on the drawing board, going to make the first few out of aluminium. Been asked for these quite a lot recently so
here goes :)
Bob
I have no use for a .30 cal Mag....
But it being made out of Aluminum!!!!
You need to put some Photos of your Creation!!!
Stuart
Hi DrBob,
Instead of just doing the 30 cal mag why don`t you do the full , to convert your Rapid fully into a 30 cal now that would be great, Not quite sure if i would go for a 30 cal Rapid but you never know who would,
:)
Here's one pic.
Yes please in.22.
Regards kev.
Now that is what I call is a Real Mag for the Rapid!!
Stuart
Just the rotor to sort out these are in .20. That's Alex just doodling ::) or a engineering equivalent. He says, " I don't do plastic".
Bob
Quote from: Dr Bob on February 24, 2022, 06:46:47 PM
Just the rotor to sort out these are in .20. That's Alex just doodling ::) or a engineering equivalent. He says, " I don't do plastic".
Bob
I think I am starting to Really like Alex!!
He is my type a machinist!!
I really hate all the Crap out there.... 3D printed crap!!!
That is What I call Machining!!
I am assuming he has a rotary 4-axis...(only way to make the mag bodies on a CNC MIll)
I should be a Snap to Him.... I am just starting to play with 3D CNC machining!!
Stuart
Maybe a daft question but would it not scratch the main body of the rapid block being made out of alloy.
I alway thought that's why theoben made there mags from plastic.
Dunno
:)
The hard anodizing on the block/action is just that. It's like porcelain. The rear of the mag will be supported by the barrel, the front is protected by the cover. The only part to wear would be the base slot on initial engagement. Theoben made them out of Delrin due to cost.
Bob
No longer on the drawing board. Excuse the .22 front cover not had chance to laser cut some 30 cal ones yet but here we have a 10 shot 30 cal Theoben mag ;) ;) ;) I'll get some probes sorted and start playing.
That is Pure Gold!!
A Winner in Rapid Market Place!!!
Good One Dr Bob!!!
Stuart
Another great product from you Dr Bob.
Look forward to some in .22 you are on a winner there.
Regards kev.
Nice, i will be ordering those ;D
Any plans to make mags for the RAW hmx action's?
thanks.
If there are enough enquiries to do a batch yes no problem.
You'll have to excuse my ignorance, but what's the difference from standard?
Bob
Quote from: Dr Bob on May 12, 2022, 03:22:14 PM
You'll have to excuse my ignorance, but what's the difference from standard?
Bob
Well I didn't know this either???????
From RAW's website..
QuoteDescription
Multi shot magazine, 17 shot in .177, 12 shot in .20/.22/.25 cal
Will fit HM1000 and All Theoben Rapid Rifles
Please note these magazines will not fit an HM1000x rifle, only the HM1000 or a Theoben Rapid
HM1000x has a serial number starting with HMX..........
How are doing Dr Bob??
Atb,
Stuart